![]() ![]() I double check yet again that I have set the target altitude of 3600 feet, that AP is on, and FLC is on. I wait for another 30 seconds and I’m not climbing and the altitude is staying at 3000 feet. The vertical speed indicator will briefly go up a little and I see a climb rate of 100 feet per minute or so, and then it just drops back to the neutral position and I don’t see a climb or descent rate. Except this time, it won’t climb with FLC set to “On.” I have double checked and the AP button is still clicked and the G1000 is still in AP mode (it says AP in green). Once it is set to 3600 feet, I then click the FLC button to turn it to “On.” I am still set to full throttle in the Cessna 172. So using the altitude knob on the bottom left, I set it to 3600 feet. By MOBLCIBI in forum FSX Replies: 2 Last Post: 12-18-2013, 01:59 AM. Then, ATC tells me I have to climb further to 3600 feet and to expedite my climb. Cessna 172 G1000 Repaint Request Can one of you willing painters repaint the Default C172 G1000 with the colors of Civil Air Patrol Heres a sample. The Cessna 172 climbs and eventually levels out at 3000 feet. All other controls work fine, Yoke, Pedals, Trim. I was able to cut engine off in XP with throttle idle and mixture pulled back. Can cut off power and mixture completely only with keyboard. Worked fine in XP but am now using windows 7. ![]() Then I click the FLC button to turn it to “On” and then I click the AP button. FSX defualt 172 without G1000 Have same problem with Saitek TPM. So using the altitude knob on the bottom left, I have set the altitude to 3000 feet. Either FLC is really buggy or I’m not using it right.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |